11.5

140 Effects and effect plug-ins
www.magix.com
Track delay/reverb
Samplitude 11.5 Producer provides two different dynamics echo/reverb
modules: one that can be opened via the "Offline effects" menu and which
shall be talked about in further detail in the corresponding chapter, and a
second one that is only available via the track effects and in the mixer.
Use this editor to calculate an echo effect into a sample. To avoid
overmodulating the sample, there should be a certain volume control reserve,
i.e. the sample data should not be allowed to reach the maximum/minimum.
This can be accessed using the normalization function (some 70%), if required.
Echo delay / Rev. time: This button displays the delay between the individual
echoes/original signal and the first echo in seconds. You should note that the
delay is dependent on the sample rate, that is, a change in the sample rate
after creating the echo leads (logically) to a change in the echo delay.
Reverb properties: Here the values for the size of the simulated room and the
reverb coloration can be specified numerically as well as by using the scroll
bars.
Wet/Dry balance %: Here the dampening between the individual echoes can
be entered as a percent. A number close to 100% results in slower sounding
echoes, a value under 40% has quick sounding delays.