11.0

484 General settings
www.magix.com
Send echo (without fader touch): The MIDI controller data is
received, processed and returned to the controller. However, the
fader values are not sent back while it is moved (activated fader
touch). Only the last value is released to prevent increased data
volumes. Program data (e.g. fade changes in the mixer) are sent to
the controller. If your controller has difficulties with this (e.g. Logic
Control), activate "Normal send".
Adjusting the hardware controller/creating your own set
Most devices available on the market understand protocols such as
Mackie Control or HUI. If your device is not included in the list simply
select the nearest compatible device.
If you can't find your device in the list or want to change the default
settings, you should proceed as follows:
Before adapting an existing template to your controller you should
save it under a new name using the "Save as..." option.
Now go to the "Adapt controller" tab. The following dialog will
appear:
Use Mackie Control if your controller can emulate this mode. In this
case 7-bit values are transmitted. You can see this in the MIDI input
monitor. Pressing a key displays a new line, another line is displayed
upon key release. HUI receives 14-bit messages, i.e. two lines
respectively.
In the parallel opened mixer you can now select the element you
want to program on your controller. The saved function is displayed
in the Program function section, e.g. "Fader master" for the fader in
Samplitude 11 Producer's mixer. Alternatively, you can open the