11.0

Effects and effect plug-ins 139
www.magix.com
Attack: Sets how quickly the algorithm takes to react to increasing
sound levels.
Release: Sets how quickly the algorithm takes to react to falling
sound levels.
Gate level: This parameter specifies which levels should be set to 0.
Track delay/reverb (track effects)
Samplitude 11 Producer provides two different dynamics echo/reverb
modules: one that can be opened via the "Offline effects" menu and
which shall be talked about in further detail in the corresponding
chapter, and a second one that is only available via the track effects
and in the mixer.
Use this editor to calculate an echo effect into a sample. To avoid
overmodulating the sample, there should be a certain volume control
reserve, i.e. the sample data should not be allowed to reach the
maximum/minimum. This can be accessed using the normalization
function (some 70%), if required.
Echo delay / Rev. time: This button displays the delay between the
individual echoes/original signal and the first echo in seconds. You
should note that the delay is dependent on the sample rate, that is, a