11.0

106 Effects and effect plug-ins
www.magix.com
Maximize: Use this controller to strengthen the room sound which
also increases the stereo transparency without influencing mono
compatibility.
Multiband: This can be used to switch Stereo FX to Multiband mode.
Stereo editing only applies to the middle frequency, the bass and
highs remain unchanged.
Stereo meter: This provides a graphical display of the phase relation
of the audio signal. You can use it to review the orientation of the
signal in the stereo balance and the effect of the stereo enhancer. To
keep mono-compatibility the "cloud" shown should always be higher
than broad. Otherwise some frequency ranges may cancel each
other out if the stereo signal is played on a mono device.
MultiMax
MultiMax is a compressor with three independent frequency bands.
Dynamic processing takes place separately for each band.
The main advantage of a multi-band compressor over a ”normal”
compressor is that warping and other disturbing side effects are
drastically reduced by dynamic processing. This means that a single
peak level in the bass section will not drag the level of the whole
signal down.
Multi-band technology also enables precise treatment of individual
frequency bands.
Frequency band settings: Adjusted directly in the graphical display.
Simply click on the dividing lines to shift the levels.
Bass/Mid/High: Regulates the degree of compression for each
frequency band.
Limiter: MultiMax contains a limiter that harmonizes levels, e.g. higher
levels are automatically reduced, and quiet passages remain
unaffected.