X

EFFECTS MENU 739
VariVerb - Overview of Details
When you open VariVerb for the first time, the device will open in a kind of "Easy" mode.
The Display is the core of VariVerb, since this visualizes the available parameters, their
current values, and a graphical visualization of the reverberated envelope.
The preset list is located above the device interface in the console, where you will find the
typical settings for various everyday studio work tasks.
For general AUX routing, there is a
separate category featuring all
models available in a "default"
setting. This section can be used to
design reverb (if you want to start
from scratch). The mixing ratio is
preset to 100%.
The controller for the mix ratio is
located on the right of the main
interface (direct signal and reverb
portion).
To the left, the "test" section and a "mute" button are provided.
You can use these to temporarily switch off the input
signal during longer reverb decay periods, i.e. if you want
to judge the resonating reverb precisely.
On the other hand, a muted input can be useful for more
complex room design using the test samples: these allow
acoustic evaluation and fine tuning of the reverb effect
using three samples: stick (sidestick), snap (finger snap),
and vocal (short vocal sample).