X

EFFECTS MENU 639
In the "Fade start" or "Fade end" filter mode, fading is not applied uniformly.
In this case, select the highest setting for the filter parameter precision in the "Expert"
dialog. In "Direct" fade mode, the problem is reduced when the rate is reduced.
Experiment in the other blend modes with this parameter to find a suitable setting.
Brilliance Enhancer
(Optional as part of the Cleaning/Restoration Suite)
You can find more information on the Cleaning/Restoration Suite in the PDF document
"Cleaning/Restoration Suite" included with the program.
Filtox
More information is available in "Effects -> MAGIX plug-ins (view page 698)".
Delay/Reverb
Delay
Use this function to integrate an echo effect into a sample/object. To avoid overmodulation,
you should set up a certain modulation reserve.
Echo delay/reverb time: This controller sets the delay between the individual echoes or
the original signal and the first echo in milliseconds. Note that the delay is dependent on
the sample rate, i.e. a change in the sample rate after creating the echo leads (logically) to
a change in the echo delay.
Decay: Set the decay value for the simulation of the size of the room numerically as well as
using faders. In "Offline" mode, there is also a "ping pong" effect available, and you can
also set the reverb chamber in the real time dialog.
Mix balance in %: Enter the ratio of the original signal to the echo/reverb signal in percent
here. If you switch on the "Link" option, both values always add up to 100%.