X

SYNCHRONIZATION 349
MTC (MIDI Timecode)
MTC Input
MTC input active: This check box activates the input for the incoming MIDI Timecode
signal.
Device: Select the device that should create the MIDI timecode signal for synchronization.
MTC output
MTC output active: This check box activates the output for the MIDI timecode signal
generated by Samplitude.
Device: Select the device that the MIDI timecode signal should be sent to for
synchronization.
ASIO positioning protocol (APP) input
APP Input
APP input active: This check box activates the input for the incoming APP input signal.
Preroll time: In order to hinder problems during starting, you can set the preroll time at up
to 1500 milliseconds.
APP output
APP output active: This check box activates the output for the APP signal generated by
Samplitude. Please make sure that the APP output from the ASIO hardware is supported.
Information concerning the generation of SMPTE timecodes within Samplitude is presented
in the menu item "Effects -> SMPTE generator (view page 775)".
No automatic record stop in MTC input mode
If Samplitude is receiving MTC from an external device and the corresponding track is
ready to record, Samplitude will begin recording as soon as the external signal is recorded.
If sending of external synchronization signals stops, Samplitude will end recording and
enter into playback mode automatically. If timecode is received again, Samplitude will begin
playback. In any case, if you want Samplitude to record again when receiving MTC, then
activate this option.
MTC Output also in stop-status
If you select this option, Samplitude continuously sends the current time position as MTC –
even in case playback has stopped.