MX

Arranging Objects 69
www.magix.com
Adjusting volume/brightness
With
the volume/brightness handle in the top center of the object, you can
change the volume of audio and MIDI objects or adjust the brightness of video
and bitmap objects.
If several objects are played in parallel, it is possible to individually adjust the
volume or brightness ratios between objects in this manner.
The volume and brightness ratios between tracks are adjusted in the mixer.
"Draw in" loops
Audio loops can be drawn into the arranger tracks with the mouse.
For this you have to set the mouse mode to "Draw objects" by clicking
on the corresponding icon in the mouse modes menu. Now an audio
sample has to be loaded which will serve as a template and which will
then be drawn into the following area of the track as a loop in the track.
This works as follows:
1. Load any loop from the Media Pool into the arranger.
2. Click on an area further back on the same track and hold down the mouse
button to draw in the loop.
Starting from the first object, the drawn-in loop area is always synchronous
with the beat. This means that the drawn-in loop is not played from the
beginning, but rather starts from the position where the original loop would be
if you had continued to this position. Or, to put it differently, a running loop can
be found on the track and you can draw in at which position you can hear it
("Mute automation").
The synchronous start of the object in this mode has another consequence: If
an object is moved, then only object borders are moved, but the underlying
loop, however, always remains intact.