2.0

Function Window 39
MAGIX Digital DJ 2 will behave as if the music was coming from a CD
in the CDJ itself.
- Vinyl - Select ms PINKY gen 1,2,3,4 or CD, Torq or Reflex PCDJ. If
you have any other brand of timecoded vinyl, set mspinky generation
to "4" and use the LEARN TIMECODE function as described below.
Supported formats - Fully tested and supported formats include: Final
Scratch, MixVibes, ms PINKY (Gen 1 to 4), Serato Scratch Live and
Torq timecodes. All other control sources are supported through the
vinyl control record speed 'LEARN TIMECODE' system.
 INPUT THRU - Passes audio inputs through to MAGIX Digital DJ 2 output.
Use this to play regular vinyl records (make sure that the associated deck is
set to 'Internal tracking' so that the turntable input is not treated as a control
signal). If you are using a control vinyl when INPUT THRU is "on" you'll hear
the tracking signal "whistle" in the mix. Useful when setting up your rig, but
your audience probably won't like it if you forget to turn in off :)
 LEARN TIMECODE - Calibrate Deckadance to the default speed of your
timecoded vinyl (if you are using a CD see the section on Timecoded CD
(CDJ) above). To obtain the most accurate vinyl calibration:
1. Ensure your setup is correct and that you have a 'healthy' tracking signal on
the input, at approximately 50%-70% amplitude.
2. Play the record or CD at normal speed (important with normal/reset pitch in
your turntable!).
3. Press 'learn' and hold for 3 to 4 seconds.
4. Release 'learn' and you're done!
 GAIN - Adjusts the input level for the associated deck. Tips to obtain an
accurate lock on the tracking signal on the record. The signal level from your
turntable is important, it should be set to about 50-70% from the center of the
oscilloscope window to the edge. A signal that is too loud will clip and
degrade the tracking signal. A signal that is too low can lead to phase
ambiguity and so affect spin direction detection.
 RUMBLE - Rumble Threshold, ignores input audio signals below the
threshold level. Use Right Mouse Button to reset to -50.0 dB.
 LEAD IN - Coming soon.