1.0

46 Settings
Troubleshooting
1. Make sure you are using the latest version of ASIO4ALL, install it and try
again. The latest ASIO4ALL driver will be available at www.asio4all.com.
Don't be afraid to try the latest Beta (if there is one).
2.
Unavailable - If any of the inputs/outputs of the devices in the 'WDM
Device List' have a RED X through them, it means they are probably being
used by another audio application. For example, programs such as 'MSN
Messenger', 'Skype', media players etc. can tie up inputs/outputs so, close
Deckadance, close any program that may use your sound card and
re-open Deckadance and the ASIO4ALL options.
3. Nothing shows - If your sound card or its IN/OUTputs don't show in
advanced mode, try downloading the latest driver for your soundcard. This
happens when the driver for your soundcard hasn't registered itself
correctly with Windows.
4. No sound - Check the following:
- Select all Outputs - In 'Advanced view' expand your Soundcard
Inputs/Outputs and ensure all Outputs are active. In the example
above, the Creative SB X-Fi has its main analog output selected ('Out:
8x 44.1 1-192kHz, 32Bits') but the 'SPDIF' Output and 'Plantronics
Head' set Output ('Out: 2x 6 4-48 kHz, 16 bits') are both deselected
and so would not be available in the Audio settings (view page 41).
- Main Outputs - Make sure your ASIO Output is selected in the Master
OUT Audio settings.
- Switches - Try the 4 possible combinations of the 'Always resample
44.1 kHz <> 48 kHz' and 'Force WDM Driver to 16-Bit' switches
(Off/Off, On/Off, Off/On, On/On).
- Any sound? - If there is still no sound, make sure you can hear sound
from other Windows programs. If not then your problem isn't related
to ASIO4ALL (try re-installing your soundcard drivers).
- Output Errors? - Make sure the Outputs are not showing Unavailable
or Beyond logic as described elsewhere in this section.
5. Crackling noises without the underrun count increasing - Check the
following:
- Switches - Try the 4 possible combinations of the 'Always resample
44.1 kHz <> 48 kHz' and 'Force WDM Driver to 16-Bit' switches
(Off/Off, On/Off, Off/On, On/On).
- Hardware buffer switch - Try On/Off.
6.
Beyond Logic – similar to "Unavailable". If the control panel of your
card provides the option to lock the sample rate deselect it, a known cause