17.0

Cleaning 87
www.magix.com
You can select as many distortions in the editor window as you want and
remove them all in one go.
There are three small buttons visible at the position of your selection.
Delete: Removes the selection.
View original: Normally the result of the noise removal is depicted
in the selection. If you click on this button however, you will see
the original signal which contains the noise.
Bypass: Normally the result of the noise removal is played back
in the Spectral Cleaning Editor. If you click on this button, it will
play the original signal.
If you wish to perfect the result, set the play cursor in front of the selected
distortions and listen carefully to the whole track (see playback section). If
necessary, change the distortion selection. As a rule of thumb, as short a
section as possible should be selected.
Sometimes it's necessary to modify the effects parameters (see Controls, Edit
selection). If you are happy with the result, then press "Calculate".
The result of Spectral Cleaning is saved in the original audio file and the editor
is then closed.
Controls
Toolbar
You can assign various tools to the toolbar using the left and right mouse
buttons. The selected tools are marked in blue if selected with the left mouse
button, in red for the right mouse button.
Selection tool: Use this tool to modify selections.
Drawing tool: Use this tool to select distortions or to modify the
selection.
Double-clicking on the selection applies it to the entire frequency range.
Navigation tool: You can move the displayed range by
holding down the mouse button and moving the mouse.
Zoom tool:
Left mouse
button (click):
Zoom in