6.0

Text options
This duplicates many of the controls on the Text toolbar. If there is a selected area of text, any changes
apply only to the selected characters.
Options at the top of this dialog box (left–right)
Bold:
Make the text Bold.
Italic:
Make the text Italic.
Outline: This duplicates outline in the Extrude
options
(described earlier.)
Font size:
Dimmed unless there is a selected area of text. Lets
you make the selected characters smaller (below
100%) or larger (above 100%) than other
characters.
Aspect ratio:
Lets you compress (below 100%) or expand (above
100%) character width. Values below 80% or above
120% can distort the text—this depends on the font
used.
Justification:
(also known as alignment.) Has no effect for a single
line of text. For multiple lines you can align the
left-hand edges, the centers or the right-hand edges of
the lines.
Line spacing:
Has no effect for a single line of text. For multiple
lines this alters the spacing between the lines. Line
spacing always applies to the entire line. If you have a
selected area of text, any changes apply only to the
line or lines containing the selection.
Tracking:
This controls the spacing between characters.
Negative values move the characters closer together,
positive values move them apart.
Baseline shift:
Page 82