Operation Manual

8
5.2. Connection of camera
To supply your camera with power it must be connected to the connecting cable of your
vehicle´s reversing lights. The camera is then activated every time the reverse gear is
selected.
Connect the red camera cable to the positive cable of the reversing lights and the black
cable to the negative cable. The positive cable is normally coloured, whist the negative
cable is generally black. For absolute certainty the correct cables should, however, be
determined by measuring or checking with the manufacturer.
Ensure that the cables are accurately connected and insulate the connecting points to
preventbadcontactsandshortcircuiting!
5.3. Installation of mirror
Attach the mirror and integrated display to the existing rear-view mirror of your vehicle as
follows:Positionthebottomxtureontherearofthemirroragainstthebottomofthe
rear-viewmirror.Slidetopxtureupwardsandpushoverthetopedgeoftherear-view
mirror.Assoonasyouletgoofthetopxings,thexingswillclamparoundtherear-view
mirror. Additionally secure mirror using existing rubber bands.
Camera
Connector
Transmitter box
Antenna
Red LED
Power cable
red
black
Reverse
lamp
wire clamp
wire clamp