Operation Manual

68 69
IRLUK
SettingsSettings
IRL UK
All data required for the used wireless network are stored in
the router or Access Point through which the network is cont-
rolled. Select the router or access point settings and open the
wireless network settings. Further information of how you
can find this data is provided in the manual of your router or
is available from your System Administrator.
2. Network name (SSID): Enter the name of your wireless
network (also referred to as SSID).
3. Region: Depending on the region, W-LAN does not sup-
port various channels. Select the region in which the IP
security camera will be used from the “Region” option.
4. Encoding: Data in wireless networks are in most cases
transmitted encoded to prevent third-party access. State
what type of encoding is used in your W-LAN network.
When “Uncoded“ is selected, data are not encoded prior to
transmission. When using“WEP“, “WPA“ or “WPA2“ encoding,
additional encoding information must be provided. Enter the
same settings as shown for the router or access point.
NOTE!
− Enter wireless network settings without
changing. This is the only way to ensure the
correct connection of the IP security camera.
− Also, general settings of the router or access
points should not be changed where this
is not required. Otherwise this could result
in problems with other WLAN devices in the
network.
Use the “Search“ function to start an automatic search of
existing wireless networks. Select the desired WLAN network
from the list by marking it under “Selection” and click on
“Use“. Where encoding data is required for the selected net-
work, these must still be entered.
Click on “Apply“, to accept the changed settings. Next, restart
the IP security camera to accept the changes. The restart ta-
kes about 2 minutes.