Operation Manual

9
AFTER SALES SUPPORT
AUS
1800 623 432
MODEL: CRB-100 PRODUCT CODE: 48144 12/2014
Note:
• Outer trim frame, hook, and mounting sleeve are not used for this installation.
• This is only intended as a general guide; contact the vehicle’s manufacturer for
specic instructions.
• This method of installation uses the screw holes at the sides of the unit and the
holes of the existing vehicle mounting bracket.
1. Remove the hooks on both sides.
2. Align the screw holes of the mounting bracket supplied with the car and the screw
holes of the main unit. Tighten the 2 screws on each side of the unit. Then fasten the
brackets to the car.
3. Attach wires of the unit to existing speaker wires. See wiring diagram.