GAS GRIDDLE INSTALLATION & OPERATION MANUAL MKG24, MKG36, MKG48, MKG60 & MKG72 Built After June 1, 2003 MAILING - P.O. BOX 501, CONCORD, NH 03302-0501 SHIPPING - 10 FERRY ST. CONCORD, NH 03301 TEL: 800-258-3708 • 603-225-6684 • FAX: 603-225-8497 www.magikitchn.com L25-050 Rev.
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE FOR YOUR SAFETY DO NOT store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WARNING Improper installation, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment.
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION Table of Contents 1. INSTALLATION SECTION:................................................................................................................................................... 1 1.1. CHECKING YOUR NEW GRIDDLE: ......................................................................................................................... 1 1.2. INSTALLATION CLEARANCES:....................................................................................
MKG SERIES GAS GRIDDLE 1. INSTALLATION & OPERATION INSTALLATION SECTION: 1.1. CHECKING YOUR NEW GRIDDLE: Your new griddle has been carefully packed into one crate. Every effort has been made to ensure that your new griddle is delivered to you in perfect condition. As you unpack your new appliance, inspect each of the pieces for damage. If something is damaged, Contact the shipper immediately; the shipper is only responsible for 15 days after delivery.
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION WARNING NEVER supply the appliance with a gas that is not indicated on the data plate. Using the incorrect gas type will cause improper operation. If you need to convert the appliance to another type of fuel, contact your dealer. 1.3.1. Fuel Types: Each appliance is equipped to work with one type of fuel. The type of fuel with which the appliance is intended to operate is stamped on the data plate, see figure 1.
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1.5. INSTALLATION, SET UP: The installation of this appliance MUST conform to local codes. In the absence of local codes, the installation must conform to the National Fuel Gas Code, ANSI Z223.1; Natural Gas Installation Code, CAN/CGA-B149.1; or Propane Installation Code, CAN/CGA-B149.2 as applicable. A. Uncrate appliance and locate installation accessories shipped with the appliance. 1.5.1.
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1.5.3. For Use on Optional Equipment Stand: ATTENTION Rear mounting brackets should be installed to the Equipment Stand prior to placing griddle on the stand. CAUTION Only two of the four supplied casters are equipped with a locking feature. Install the griddle so that the two locking casters are at the front of the unit. The casters should be LOCKED before the unit is placed into operation. (See pictures this page).
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1.6. FINAL GAS CONNECTION: A properly installed gas supply system will deliver adequate pressure (7 to 8 inches w.c. for natural gas, 11 to 12 inches w.c. for propane) to all appliances connected to the line, operating at full demand. 1.6.1. Regulator Assembly: An adequate gas supply is important for the appliance to operate properly. Undersized lines or low-pressures will restrict the volume of gas required for satisfactory performance.
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1.6.2. Gas Settings: Orifices are sized to provide proper gas flow to the rated BTU/hr for each model. Regulator pressure must be measured and adjusted before the unit goes into service, following installation and when operational performance is in question. Gas Type BTU/hr(kW) Per Burner Natural Propane 15,000(4.4) 15,000(4.4) Manifold Pressure WC" (Matchless) 4.0"(10.1cm) 10.0"(25.4cm) Manifold Pressure WC" (All Others) 4.5"(11.4cm) 10.0"(25.
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 2.2. INITIAL STARTUP: NOTICE: New griddles should be carefully tempered and cared for in order to avoid possible damage. To break in a new griddle, do the following: Wipe the griddle surface clean. A mild soapy water solution may be used to clean the surface, if this solution is used be sure to rinse thoroughly with fresh water to eliminate any soap residue. Also it is important to wipe the griddle surface and surrounding areas to dry up any standing water.
MKG SERIES GAS GRIDDLE 3. INSTALLATION & OPERATION THERMOSTAT CALIBRATION SECTION: Each control typically operates a pair of burners with a Snap action, Electric or Solid State. The controls were set at the factory. However, if the griddle’s surface temperature varies greatly from the setting on the thermostat knob, adjust the thermostat using the following procedure: 3.1. CALIBRATION PROCEDURES: 3.1.1. Snap Action and Electric Thermostats: A. Light pilots per lighting instructions. B.
MKG SERIES GAS GRIDDLE 4. INSTALLATION & OPERATION BASIC OPERATION: 4.1. OPERATIONAL HELPFUL HINTS: A. Each thermostat controls 12" of griddle surface, whenever possible, use the leftmost or rightmost thermostats for the lowest cooking temperatures. The adjacent thermostats set at higher temperatures will effect centrally located thermostats. B. For quicker thermostat response during heavy loading of the griddle, load product directly over the thermostat sensing probe.
MKG SERIES GAS GRIDDLE 5. INSTALLATION & OPERATION CLEANING & MAINTENANCE SECTION: 5.1. DAILY CLEANING: A. Clean the griddle surface often to prevent sticking and poor quality of food product. Scrape the griddle plate regularly with a scraper intended for your type of griddle surfaces to remove all surface grease and food debris. NOTICE: Do not use Grill Bricks, Grill Screens, or any other type of abrasive material on your MagiKitch'n Chrome Griddle Surface.
MKG SERIES GAS GRIDDLE F. G. INSTALLATION & OPERATION Check to see that the ventilation hood and make up air systems are working properly. Any make up air system should not be directed as to impede the flow of combustion air to the griddle, or flue exhaust from the griddle. Inspect griddle surface for proper cleanliness. 5.4. TROUBLESHOOTING CHART: The following chart may help to eliminate any basic operational problems that you may be experiencing with your appliance.
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION Using MagiKitch'n chrome griddle accessories are important to maintaining the life of the griddle's chrome surface. 5.5.2. Optional: To order accessories for your griddle, call your local MagiKitch’n dealer for prices and availability.
MAILING ADDRESS - P.O. BOX 501, CONCORD, NH 03302-0501 SHIPPING ADDRESS - 10 FERRY ST. CONCORD, NH 03301 PHONE- 800-258-3708 • 603-225-6684 • FAX: 603-225-8497 www.magikitchn.
