Manual

Operations
MKG Series Gas Griddle
L25-052 R3 (04/12)
9
LEFT PIEZO IGNITOR
RIGHT PIEZO IGNITOR
LEFT PILOT BUTTON RIGHT PILOT BUTTON
PILOT HOLES
METHOD
A
PILOT READY LIGHT(S)
PILOT HOLES
METHOD
B
ON/OFF(I/O) SWITCH
2. Operation Section
Ensure that a proper installation has been performed on the appliance and that all warnings, cautions, and
notices contained in this manual have been read, understood and adhered to before proceeding.
2.1. Lighting Instructions
2.1.1. Snap-Action Thermostat Appliances
1. Turn all thermostat knobs to the “OFF”
position.
2. Open front door of the griddle, turn the
manual gas shut off valve to the “ON”
position, see Figure 6.
3. Press and hold the left or right RED pilot
button, see detail Method A at right, and light
the left or right pilot by depressing the Piezo
ignition control, look through the pilot hole to
see the pilot ignites. With pilot burning, keep the RED pilot knob depressed for 45 seconds or until pilot
remains lit automatically. If the Piezo ignition control does not light the pilot(s), a flame source can be used to
light the pilot(s) through the pilot holes provided in the front panel of the appliance.
4. Repeat steps 1,2, and 3 for all remaining pilots.
5. Operate thermostats by turning knobs clockwise to the desired temperature and insure that burners light
properly by looking through the pilot holes provided in the front panel.
2.1.2. Solid State And Electric Thermostat Appliances
1. Turn all thermostat knobs to the “OFF” position, or the lowest possible temperature setting.
2. Turn the Manual gas shut off valve to the "ON" position, this valve is located at the rear of the unit, see
Figure 6.
3. Turn the RED "I/O" switch to the “ I ” (ON)
position for all desired Thermostats to be
operated, See detail Method B at right. When the
Pilot ready (Amber) light illuminates, the pilot(s)
are ready to operate the main burners.
4. Repeat steps 1,2, and 3 for all thermostat
controls to be operated.
5. Operate thermostats by turning knobs
clockwise to the desired temperature and insure
that burners light properly by looking through the
pilot holes provided in the front panel. The RED
"I/O" switch will illuminate when the thermostat
calls for heat.
CAUTION
If Pilot Ready light(s) does not illuminate, Turn all Thermostat "I/O" switches for that pilot to
“O”(OFF), wait five minutes before attempting to re-light.
If Pilot(s) extinguish or gas supply is interrupted, turn thermostat knobs and the gas shut off valve to
the "OFF" position and wait 5 minutes before attempting to re-light.