Instructions

To find the best temperature one could start from the lower end of the
recommended settings and increase the bed temperature in 5 °C
increments. This should be done with standardised calibration prints.
An additional benefit of Magigoo® - Metal, being highly water soluble, is that
the green part can be easily removed after soaking the build-plate in water
for 30 minutes to a couple of hours (depending on size). This ensures that
the part is not damaged when being removed.
The best and most reliable performance is achieved when applied as a thin
layer. This means that cleaning and re-applying between prints is
recommended especially on longer prints or hard to print with materials.
Storage and Handling:
Magigoo® - Metal, should be stored in a cool dry place away from direct
sunlight. After use Magigoo® - Metal should be stored in an upright position
and with the cap on.
Excess Magigoo® - Metal on the nib can cause the applicator adhering to
the cap. To prevent this, make sure no excess Magigoo® - Metal remains on
the rim of the applicator after use. If not capped the Magigoo® - Metal
applicator will dry up. In such a case just rinse with water.
[e-mail]
www.magigoo.com
MAGIGOO
Thought3D Ltd, Unit2150, KBIC, Kordin Industrial Estate
Paola, PLA3000, Malta
2