Instructions

!
To find the best temperature one could start from the lower end of the
recommended settings and increase the bed temperature in 5 °C
increments. This should be done with standardised calibration prints.
An additional benefit of MAGIGOO® - High Temperture, being thermally
activated, is that it will release the print upon cooling. Again, different
printers, print surfaces or filaments will have slightly different released
conditions but as a general rule a reduction in temperature of 30-40 °C will
be sufficient to remove your prints without any effort.
The best and most reliable performance is achieved when applied as a thin
layer. This means that cleaning and re-applying between prints is
recommended especially on longer prints or hard to print with materials.
Storage and Handling:
MAGIGOO® - High Temperature, should be stored in a cool dry place away
from direct sunlight. After use MAGIGOO® - High Temperature should be
stored in an upright position and with the cap on.
Excess MAGIGOO® - High Temperature on the nib can cause the applicator
adhering to the cap. To prevent this, make sure no excess MAGIGOO® - High
Temperature remains on the rim of the applicator after use. If not capped
the MAGIGOO® - High Temperature applicator will dry up. In such a case just
rinse with water.
2
[e-mail]
www.magigoo.com
MAGIGOO
Thought3D Ltd, Unit2150, KBIC, Kordin Industrial Estate
Paola, PLA3000, Malta
2