Instructions

Step 1: Shake the bottle vigorously.
NB! Shaking too much might cause bubbling. This does not
negatively affect adhesion but does not provide a mirror finish
on the bottom of the print
Step 2: Press nib against the surface.
NB! The Magigoo – Flex container is spring activated. Pressing
the bottle without pressing the nib against the bed may result in
applicator popping off and product wastage.
Step 3: Apply liberally to desired area
NB! For better adhesion of challenging prints, apply one layer
first. Let it dry and apply another layer on top.
Step 4: Print
NB! After print, wait until the build plate is cool to remove prints
easily. Apply water around the part and wait for a few minutes
before attempting removal if part is hard to remove.
Step 5: Clean
NB! Just wipe off with a damp cloth. Use just water.





[e-mail]
www.magigoo.com
MAGIGOO
Thought3D Ltd, Unit2150, KBIC, Kordin Industrial Estate
Paola, PLA3000, Malta
3