Instructions

[e-mail]
www.magigoo.com
MAGIGOO
Thought3D Ltd, Unit2150, KBIC, Kordin Industrial Estate
Paola, PLA3000, Malta
Description:
MAGIGOO® - Flex (Flexible filaments – TPUs, TPEs), is an all-in-one 3D printing
adhesive that offers sure adhesion with easy removal for flexible materials.
MAGIGOO® - Flex, has been specifically formulated for flexible filaments to ensure
that it provides an easy to use solution to reduce warping in FDM/FFF 3D printers.
Warping, among other factors, is caused by the differential cool of a print during a
3D printing process. MAGIGOO® - Flex is purposely developed to reliably and
repeatably minimise warping during FDM/FFF printing of flexible materials.
Technical specifications:
‣
Appearance: clear-faint yellow liquid
‣
Consistency: low-med viscosity
‣
Solvent: water
Properties:
MAGIGOO® - Flex, acts as a thermally activated interfacial layer, allowing
for better interactions, both at the micro and molecular level, between the
printing bed and the printing materials. It is generally recommended to
print according to the printing temperatures recommended by the filament
supplier. The printing conditions vary between one printer and another.
To find the best temperature one could start from the lower end of the
recommended settings and increase the bed temperature in 5 °C
increments. This should be done with standardised calibration prints.
Intended use:
To be used on FDM/FFF 3D printers with a heated bed on glass surfaces. Also works
when applied on sheets e.g. Kapton, PEI and similar. To be used with flexible
filaments.
1