Installation Instructions

Thank you for selecting our product. To ensure that your installation goes smoothly, please read these instructions carefully and review the
recommended materials and tools before you begin.
• Verify that your vanity top is free from defects. If damaged, please contact our Customer Service department.
• Observe all local plumbing codes and building codes.
Questions? Call our Customer Service Department at 1-855-995-5578 or email [e-mail].
VANITY TOP
• INSTALLATION
• CARE AND MAINTENANCE
INSTALLATION
1) Ensure the vanity base surface is at, level, and clean.
2) Put a small bead of silicone on the vanity base edge.
3) Place the top on the vanity base and assure it is aligned on all edges.
4) Leave for 3 hours to let the silicone set.
a. If any warpage is obvious, put a weight on top of a towel over the high points and
leave over night for the top to settle.
b. Hand tighten all plumbing ttings; if necessary only ¼ turn with a wrench.
c. Use 100% silicone instead of plumbers putty between all rubber gaskets and O-rings.
CARE & MAINTENANCE
• Do not use water that exceeds temperatures of 140°F/46°C.
• Do not place any sharp or abrasive objects on the bare surface of the top.
• Clean the top only with non-abrasive cleaners or mild detergents - do not use powder cleansers.
For extremely stubborn stains, use a small amount of acetone on a cloth and gently rub out the stain.
Failure to follow the above instructions will void all warranty claims.
Silicone
31”W wave bowl top
shown in illustration
Magick Woods Customer Service: Phone: [phone] • Fax: [phone] • Email: [e-mail]