Installation Instructions

Figure 5: complete
TROUBLESHOOTING
Problem:
1) Vanity doors or drawers rub against
another surface.
2) There is a large uneven gap between
the doors or drawers and cabinet.
Possible Cause:
Floor or vanity is not level.
Corrective Action:
1) Use a shim to ensure the vanity is level.
2) Adjust the door hinges or drawer slides.
Figures 6 and 7.
Side adjustment:
Using a Phillips screwdriver, rotate screw (1)
clockwise to move the door left and
counter-clockwise to move the door right.
Moves the door up to 2 mm.
Depth adjustment:
Using a Phillips screwdriver, rotate screw (2)
clockwise to move the door forward and counter-
clockwise to move the door backwards.
Moves the door up to 2 mm.
Height adjustment:
Using a Phillips screwdriver, loosen both
screws (3) and adjust the mounting plate po-
sition as required to shift the door up or down
+2mm / -2mm. , then tighten the screws to
secure.
Figure 6 - Adjusting Hinges
Step 1: Release the lever on each drawer slide (push the lever on the left
drawer slide downward and the lever on the right drawer slide upward) to
release the drawer from the cabinet. NOTE: to remove the drawer, hold the
lever in place and firmly pull the drawer out.
Drawer slide
Drawer
front
Drawer slide
Drawer slide
Screws
Lever
Step 2: Using a Phillips screwdriver, loosen the screws that fasten the
drawer slide to the drawer. Shift the drawer slide as needed (up or
down / in or out). Re-tighten the screws and repeat for the opposite side
as necessary. To place the drawer back into the cabinet, align the drawer
slides with the cabinet slides and push firmly until the drawer is secured
into place.
Lever
Figure 7 - Adjusting Drawer Slides
Figure 3
Figure 4
For 31-1/8”W
and 37-1/4”W models
Knob
Washer
Screw
Magick Woods Exports Pvt. Ltd. Customer Service:
Phone: [phone] • Fax: [phone] • Email: [e-mail]