Installation Instructions

Model 30185 shown in illustrations
INSTALLATION
1: Removing old vanity (if applicable): 1) Turn o󰀨 the water supply and drain out. 2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity. NOTE: If the new vanity is not installed immediately, temporarily stu󰀨 a rag into the drain pipes.
2: Using a level, locate any uneven oor and/or wall areas where your vanity will be installed. Unevenness can cause your vanity to
become misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots.
3: 1) Provide su󰀩cient protection on the oor to protect the vanity from damage. 2) T
ilt the vanity backwards and remove the shipping
feet from the bottom of the vanity base using a pair of pliers (A - not included). Figure 1.
4: 1) Place the vanity in the desired position taking into account the location of your plumbing. 2) Ensure the vanity is level front to back
and at both sides.
5: Secure the vanity to the wall by inserting (x 2) #8 x 3” screws (C - not included) through the back rail of the vanity. Figure 2. NOTE: It
is recommended that the vanity be installed to at least one wall stud. In order to locate wall studs, you can use a stud nder or tap along
the wall until you nd a spot that sounds solid. If you are unable to locate wall studs, it is recommended that you use wall anchors
(D - not included) to secure the vanity.
6: Attach the door knobs by using the 1” screws and attach the drawer knobs by using the 1” screws. Figure 3. NOTE: For
31-1/8”W and 37-1/4”W models, attach the knob and ¾” screw along with the washer for the top non-functional drawer front. Figure 4.
7: Install the vanity top, faucet and drain (each not included) as per the instruction sheets provided with those items and ensure that
there is no leakage.
Figure 1
WARNINGS & CAUTIONS
WARNING:
Two people are required for safe installation. Take extra precautionary
measures to ensure a secure grip on the vanity base when lifting.
CAUTION:
The bathroom oor and wall must be nished prior to
installation of the vanity base.
CARE & MAINTENANCE
• To maintain the beauty of the furniture nish, avoid placing the vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by installing away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base immediately with a clean, soft and dry cloth.
Figure 2