Installation Instructions

Figure 1

Figure 2

2: Using a level, locate any uneven oor and/or wall areas where your vanity will be installed. Unevenness can cause your vanity to

become misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots.

3: Provide su󰀩cient protection on the oor to protect the vanity from damage. Tilt the vanity backwards and remove the shipping feet from

the bottom of the vanity base using a pair of pliers (A - not included). Figure 1.

4: 1) Place the vanity in the desired position taking into account the location of your plumbing. 2) Ensure the vanity is level front to back

and at both sides.

5: Secure the vanity to the wall by inserting (x2) #8 x 2” screws (C - not included) through the back rail of the vanity. Figure 2. NOTE: It

is recommended that the vanity be installed to at least one wall stud. In order to locate wall studs, you can use a stud nder or tap along

the wall until you nd a spot that sounds solid. If you are unable to locate wall studs, it is recommended that you use wall anchors

(D - not included) to secure the vanity.

6: Install the hardware, vanity top, faucet and drain (each not included) as per the instruction sheets provided with those items and

ensure that there is no leakage.

TROUBLESHOOTING

Problem:

1) Vanity doors or drawers rub against

another surface.

2) There is an uneven gap between

the doors or drawers and cabinet.

Possible Cause:

Floor or vanity is not level.

Corrective Action:

1) Use a shim to ensure the vanity is

level.

2) Adjust the door hinges or drawer

slides. Figures 2 and 3.

Side adjustment:

Using a Phillips screwdriver, rotate screw (1)

clockwise to move the door left and

counter-clockwise to move the door right.

Moves the door up to 2 mm.

Depth adjustment:

Using a Phillips screwdriver, rotate screw (2)

clockwise to move the door forward and counter-

clockwise to move the door backwards.

Moves the door up to 2 mm.

Height adjustment:

Using a Phillips screwdriver, loosen both

screws (3) and adjust the mounting plate

position as required to shift the door up or

down +2mm / -2mm, then tighten the screws

to secure.

Figure 2 - Adjusting Hinges