Installation Instructions

ManualsBrandsMagick Woods Elements ManualsBathNewhaven 36"W x 21"D Matte White Bathroom Vanity Cabinet

PACKAGE CONTENTS

Vanity top, hardware, faucet and drain not included.

Base (x1)

NEWHAVEN VANITY BASE

INSTALLATION INSTRUCTIONS

Models: 30103, 30104, 30105, 30106, 30102

Questions? Call our customer service department at 1-855-995-5578, 8:30 a.m. - 5 p.m., EST, Monday - Friday

or e-mail: contactus@magickwoods.com.

Model: 30103

24”W x 34-1/2”H x 21-1/2”D

NEW HAVEN 24"W x 21 1/2"D x 34 1/2"H VB200 ST

PART NO: 30103

Base (x1)

Model: 30104

30”W x 34-1/2”H x 21-1/2”D

NEW HAVEN 30"W x 21 1/2"D x 34 1/2"H VB200 ST

PART NO: 30104

Base (x1)

Model: 30105

36”W x 34-1/2”H x 21-1/2”D

NEW HAVEN 36"W x 21 1/2"D x 34 1/2"H VB201R ST

PART NO: 30105

Base (x1)

Model: 30106

48”W x 34-1/2”H x 21-1/2”D

NEW HAVEN 48"W x 21 1/2"D x 34 1/2"H VB202R ST

PART NO: 30106

Base (x1)

Model: 30102

60”W x 34-1/2”H x 21-1/2”D

Tools required for assembly (not included):

• pliers (A)

• tape measure

• electric drill with #2 drill bit (B)

• level

• (x2) #8 x 2” screws (C)

• (x2) wall anchors - if the vanity will not be screwed to wall

studs (D)

Estimated installation time: 2-1/2 hours (including removal

of old vanity if applicable)

PREPARATION

1: Removing old vanity (if applicable): 1) Turn o󰀨 the water supply and take the drain out. 2) Disconnect the supply lines from the

faucet. 3) Remove the old vanity top and vanity. NOTE: If the new vanity is not installed immediately, temporarily stu󰀨 a rag into the

drain pipe.

INSTALLATION

Model 30106 shown in illustrations

WARNINGS & CAUTIONS

WARNING:

Two people are required for safe installation. Take extra precautionary

measures to ensure a secure grip on the vanity base when lifting.

CAUTION:

The bathroom oor and wall must be nished prior to

installation of the vanity base.

CARE & MAINTENANCE

• To maintain the beauty of the furniture nish, avoid placing the vanity in direct sunlight.

• Avoid exposing the vanity to extreme temperatures by installing away from heat and air vents.

• Dust frequently with a clean, soft and dry cloth.

• Wipe away any water or liquid spills on the vanity base immediately with a clean, soft and dry cloth.

Summary of content (6 pages)

PAGE 1
NEWHAVEN VANITY BASE INSTALLATION INSTRUCTIONS Models: 30103, 30104, 30105, 30106, 30102 Questions? Call our customer service department at 1-855-995-5578, 8:30 a.m. - 5 p.m., EST, Monday - Friday or e-mail: contactus@magickwoods.com. PACKAGE CONTENTS PART NO: 30103 Vanity top, hardware, faucet and drain not included.
PAGE 2
: Using a level, locate any uneven floor and/or wall areas where your vanity will be installed. Unevenness can cause your vanity to become misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots. 3: Provide sufficient protection on the floor to protect the vanity from damage. Tilt the vanity backwards and remove the shipping feet from the bottom of the vanity base using a pair of pliers (A - not included). Figure 1.
PAGE 3
Drawer slide Lever Screws Drawer front Lever Drawer slide Drawer slide Step 1: Release the lever on each drawer slide (push the lever on the left drawer slide downward and the lever on the right drawer slide upward) to release the drawer from the cabinet. NOTE: to remove the drawer, hold the lever in place and firmly pull the drawer out. Step 2: Using a Phillips screwdriver, loosen both screws that fasten the drawer slide to the drawer. Shift the drawer slide as needed (up or down / in or out).
PAGE 4
BASE DEL TOCADOR NEWHAVEN INSTRUCCIONES PARA LA INSTALACIÓN Modelos: 30103, 30104, 30105, 30106, 30102 ¿Preguntas? Llame a nuestro Departamento de Servicio al Cliente al 1-855-995-5578, de lunes a viernes de 8:30 a.m. a 5 p.m, hora estándar del Este o escríbanos a contactus@magickwoods.com. CONTENIDO DEL PAQUETE Cubierta, aditamentos, grifo y desagüe no se incluyen. PART NO: 30105 PART NO: 30104Modelo: 30104 Modelo: 30103 Modelo: 30105 PART NO: 30103 NEW HAVEN 24"W x 21 1/2"D x 34 1/2"H VB200 ST 60.
PAGE 5
3: Cubra con protección suficiente el suelo donde vaya a ubicar la base de tocador, a fin de protegerlo contra daños. Recueste la base de tocador sobre la parte trasera y retire las patas protectoras de transporte de la parte inferior de la base del tocador utilizando un par de alicates/pinzas (A - no incluido). Figura 1. 4: 1) Ubique el tocador en la ubicación deseada, tomando en cuenta la ubicación de las tuberías.
PAGE 6
Guía Palanca Tornillos Frontal de gaveta Palanca Guía Guía Paso 1: Suelte la palanca en cada guía de la gaveta (empuje la palanca en la guía izquierdo hacia abajo y la palanca en la guía derecho hacia arriba) para liberar la gaveta del gabinete. NOTA: Para retirar la gaveta, sujete la palanca en su lugar y tire firmemente la gaveta. Paso 2: Usando un destornillador Phillips, afloje los tornillos que sujetan la guía de la gaveta al gaveta.