User Manual

User documentation MAGICFX® Power Shot
Page 13
5.
Secure the electric cannon with a screw
nut which is situated on the side of the
holder.
Never turn the screw nuts tighter than
necessary. This can damage the pressure
pattern in the electric cannon.
4.
Place the electric cannon in the cannon
holder.
The electric cannon can detach itself
through the pressure that is released during
the shooting. Therefore always use a
Cannon Clamp to secure it to the Power
Shot. This is especially important when
using it in a truss.
3.
Test the working of the Power Shot by
connecting the powerCON cable to the
power supply. As soon as the blue LED-
light above the Power Shot lights up you
know that the Power Shot is properly
connected. After testing, make sure that
the PowerCON cable is no longer directly
connected to the power supply.
During testing, make sure that no electric
cannons are connected to the Power Shot.
2.
Connect a powerCON cable to provide
the Power Shot with 230V~ 50/60Hz.
You can connect several Power Shots to
each other by using a powerCON loop
cable (MFX0309).
Only use grounded electricity sockets!
Ensure that the powerCON cable is not
connected to the power supply when it is put
in the Power Shot.