User manual

84 VIP User Manual
After you have selected all the sites to which you want to
publish, click on “Finish”, and move on to the next heading of
this tutorial: “Project Selection”.
Project Selection
VIP Composer is just about ready to begin publishing. But first,
it needs to know what project to publish to the current site.
(This step will be repeated for each site if you are using the
“Publish to Multiple Sites” option.)
The Publish Wizard will pop up a list of projects:
Click on the one you want to publish to the current site, and click
“Select”.
If you are always publishing the same project to a particular site,
you can set up VIP Composer to automatically select that project
for you, instead of asking every time. Consult the chapter, “VIP
Composer Configuration” for additional information.
Publishing Progress
Once publishing begins to a particular site, a status display will
appear. This display will be slightly different depending on the
connection method used, but the following options usually
apply:
The “Don’t Close When Completed” option is used for
diagnostic purposes. If you check this option, then the status
window will remain open after publishing completes
(successfully or unsuccessfully), and additional status
information not normally shown will be included in the display.
A MagicBox support representative may ask you to check this
box during a support call.