Specifications

Regulators (look like transistors with 3 leads)
[ ] Install the 10 volt (black body - marked 750L10C) regulator at IC1.
[ ] Install the 5 volt (black body - marked 750L05C) regulator at IC2.
[ ] Put the supplied 2-pin shorting shunt on header J14. Apply 12-15 volts DC to J1 and check that the
left pad of R1 is at +5 volts and the left pad of R25 is at +10 volts. A variation of +/- 0.25 volts is
acceptable for each measurement.
[ ] Write down your results/observations_________________________________________________
_________________________________________________________________________________
Your PCB should now look like this:
11