User manual

www.ultramagicard.com
RIO 2e, TANGO 2e & TANGO +L Printers USER MANUAL
Page 27 of 44
Security Options:
HoloKote™ is a high security system that ensures cards cannot be cloned. This special feature automatically prints a high
security watermark into the overcoat panel during the print cycle without incurring extra consumable costs. With the Rio \
Tango 2e, the HoloKote pattern can be customised to your logo and text.
HoloKote™ Watermark Selection:
The Watermark Selection options present two different
HoloKote™ Designs. Either can be chosen and be applied to the
printed cards; the UltraSecure™ logo is selected by default but can
be changed by clicking on the option button of the alternative
Interlocking Rings design.
SecureShield™:
CAUTION: this option should only be enabled if you use a
laminator in conjunction with your regular printer, if you do
not use a laminator then you should leave this option disabled.
SecureShield will perform in a similar way to HoloKote in that it
will print a 4 x 6 grid of graphic icons onto the card, but unlike
HoloKote it will not print the overcoat between the graphics, this is
done so that the HoloKote watermark is clearly visible through the
laminate film and so that the laminator film on the Sicura can stick
to the printed card more effectively.
Disable Custom Key:
The disable custom key option is intended for users who have
purchased their own custom HoloKote™ dongle. Select this option
to print cards without applying the custom logo to the card design.
This option is disabled by default.
HoloKote™ Watermark Rotation:
The HoloKote™ design can be rotated when it is printed regardless of whether it is an in-built design or a custom design
stored in a dongle, using the drop down list the logo can be rotated in increments of 90°. No rotation is selected by default.
HoloPatch™:
HoloPatch™ works with HoloKote to produce a highly visible gold seal on the card, printed using special card stock.
These options are not available in the ‘Card Back’ tab.
HoloPatch™ Area:
The HoloPatch area selection option can be changed from 1 to 24. Each number corresponds to a different position on the
grey grid to the right, and causes the printer to place a HoloPatch logo at that location on the card. This should be selected
to match the location of the gold HoloPatch foil square attached to the
unprinted HoloPatch™ card stock.
Colour Hole:
When enabled, the Colour Hole option will prevent any colour from being printed over the gold HoloPatch foil square
attached to the HoloPatch™ card stock. This option improves HoloPatch clarity and appearance when printing card
designs with colour over the entire area of the card.