User manual

www.ultramagicard.com
RIO 2e, TANGO 2e & TANGO +L Printers USER MANUAL
Page 21 of 44
Duplex Options:
Use the Duplex Options for selecting single or double sided printing.
Card Front Only:
The printer will only print on the front (upper) surface of the card; this option is
default for Rio printers.
Both sides: This option applies to the Tango 2e &Tango +L printer models only.
If a 2-page document is printed, the printer will print the first page on the front of the card, flip the card over and print the
second page on the back of the card thereby printing on both the front and back of the card in a single print cycle, This
option is default to Tango printers and is unavailable to Rio printers (because the Rio printer is incapable of flipping cards).
Printing Options:
Within Printing Options there are two types of card format
that can be selected, either Edge to Edge or White border,
with Edge to Edge the printer will print a card design over the
full surface of the card, whereas White Border will leave a
small white border around all four edges of the card,
select the option which is most desirable.
Number of Copies:
Controls the number of times the image is printed when you
send a card design to the printer, for example if you set the
number of copies to ‘5’ and send a single card design to
print, the printer will produce 5 identical cards. The default
value for this option is ‘1’.
Hand Feed: This option applies to the Rio 2e printer model only.
When enabled, the printer will accept cards fed by hand into the front entrance of the printer instead of feeding cards from
the card hopper at the rear of the printer; this option is disabled by default.
Laminating Options: This option applies to the Tango +L printer model only.
Use the Laminating Options to select card front, card back, or double-sided lamination.
None:
The lamination unit on the printer will not be used.
Front Only:
The printer will only laminate the front (upper) surface of the card.
Back Only:
The printer will only laminate the back (lower) surface of the card.
Both Sides:
The printer will laminate both front (upper) and back (lower) surfaces of the card.