User manual

www.ultramagicard.com
RIO 2e, TANGO 2e & TANGO +L Printers USER MANUAL
Page 13 of 44
Types Of Laminate Roll
The Tango +L printer uses two types of laminate film:
Patch Laminate – This type of laminate roll places a
patch on the surface of the card it will leave a small
border around the patch (typically 1-2mm). The roll
comes in 0.6mil and 1.0mil thicknesses and can
incorporate a holograph. Custom holographic designs
are available upon request. Contact your dealer for
details.
Overlay Laminate – This type of laminate roll covers
the full card surface from edge to edge with a thin
protective film. It can also incorporate a holograph.
Custom holographic designs are available upon request.
Contact your dealer for details.
Details of how to replace both types of laminate roll are shown below. Follow the instructions for your roll type.
Load the laminate roll into the laminator following the diagram below for your laminate film type (either Patch or Overlay) .
Make sure both spools are pushed fully towards the back. The free end of the film can be fixed to the take-up spool with a
small piece of adhesive tape.
IMPORTANT: When loading Patch type laminate roll, ensure the index marks are towards the BACK.
Make sure the film passes through the sensor.
Patch Laminate Roll Overlay Laminate Roll
6. Loading the Laminate Roll
IMPORTANT:
Laminate roll must
pass through the
sensor.