User manual

www.ultramagicard.com

RIO 2e, TANGO 2e & TANGO +L Printers USER MANUAL

Page 12 of 44

1. Open the top cover by pushing down on it and operating the release catch on the top of the printer.

2. Remove the used dye-film by gently pulling both spools upwards until disengaged from the clips. Take care not to bend and

break the clips.

3. Open a new roll of dye-film.

4. Place the loaded spool into the rear clips and press it into place. The orientation is

correct when the barcode on the end of the spool is on the left. Rotate the dye film roll

to allow the core to lock into position.

5. Place the empty take up spool into the front clips, and adjust the film tension so that

the film is lying flat and straight between the two spools.

6. Gently close the top cover until it clicks into the closed position. The printer will

automatically recognize the type of film that has been loaded and move it to the

correct printing position.

4. Loading the Dye-Film Ribbon

5. Choosing the right Lamination Film

(Tango +L Only)

Your

Printer

Lamination

Film Type

Cards Per

Film

Part Number

Clear Patch 0.6mil Laminate Roll 255

M9007-231R

Clear Patch 1.0mil Laminate Roll 255

M9007-230R

Clear Patch 0.6mil Laminate Roll With Chip Cut-Out 255 TBA

Holographic Overlay Laminate Roll With Globes

Design

500 TBA

Magicard

Tango +L

Custom Holographic Laminate Roll

Both Patch & Overlay Types Can Be Supplied

255/500

Ask For

Details