User manual

Ultra Electronics Ltd
Magicard Enduro User Manual
- 34 -
Image Position
The Image Position options enable the user to make small adjustments to the position of the printed image on the plastic
cards - this can be useful for eliminating unwanted white borders. All adjustments are with reference to the card viewed
in landscape.
Up/Down
Slider moved upwards: the image will move upwards on the card.
Slider moved downwards: the image will move downwards.
The adjustment is calibrated to: 12 steps = 1mm (approx).
Image End
Slider moved left: the End of the Image will move left (closer to the end of
the card).
Slider moved right: the End of the Image will move right (away from the
end of the card).
The adjustment is calibrated to: 12 steps =1mm (approx).
Image Start
Slider moved left: the Start of the Image will move left (away from the start of the card).
Slider moved right: the Start of the Image will move right (closer to the start of the card).
The adjustment is calibrated to: 10 steps = 0.1mm (approx).
The Image Start is unaffected.
In the event that the dye-film ribbon breaks due to printing beyond the edges of the card, it can be
repaired using Adhesive Tape; attach the broken ends together and then wind up the black take-up
spool by hand for roughly two full turns. Then, before printing again, turn the printer off and back on
again and change the Image Position settings so the dye film does not break again.
Moving the Image End slider too far left can result in the image being printed beyond the end of the card –
this will cut the dye-film ribbon.
Any movement of the Image Start position will have a corresponding effect on the Image End position.
Moving the Image Start slider too far right can result in the image being printed beyond the start of the
card – this will cut the dye-film ribbon.