User manual

Ultra Electronics Ltd
Magicard Enduro User Manual
- 30 -
This option should only be enabled if you use a laminator in conjunction with your regular printer, if
you do not use a laminator then you should leave this option disabled.
Security Options
There are four integral HoloKote™ designs embedded into the Driver. They are chosen from the “Security Options”
Menu within the “Card Front and Card Back Tab”.
SecureShield™.
SecureShield will perform in a similar way to HoloKote in that it will print a 4 x 6 grid of graphic icons onto the card, but
unlike HoloKote it will not print the overcoat between the graphics, this is done so that the HoloKote watermark is
clearly visible through the laminate film and so that the laminator film on the Sicura can stick to the printed card more
effectively.
HoloKote™ Watermark Rotation.
The HoloKote™ design can be rotated when it is printed regardless of whether it is an in-built design or a custom
design stored in a dongle, using the drop down list the logo can be rotated in increments of 90°. No rotation is selected
by default.
Holokote Map.
HoloPatch™ works with HoloKote to produce a highly visible gold seal on the card; printed using special card stock.
The HoloPatch area selection option can be changed from 1 to 24. Each number corresponds to a different position on
the grey grid to the right, and causes the printer to place a HoloPatch logo at that location on the card. This should be
selected to match the location of the gold HoloPatch foil square attached to the unprinted HoloPatch™ card stock.