User manual

Ultra Electronics Ltd

Magicard Enduro User Manual

- 2 -

The information contained in this document is subject to change without notice.

Ultra Electronics Limited shall not be liable for errors contained herein or for incidental consequential damages in

connection with the furnishing, performance or use of this material.

This document contains proprietary information belonging to Ultra Electronics Limited and may not be wholly or partially

copied, stored in a data retrieval system,or used for any purpose other than that for which it was supplied, without the

express written authority of Ultra Electronics Limited. All rights are reserved.

MAGICARD

, UltraCoverplus,, Holokote, Enduro, Ultra Shield is registered as a Trademark with the United States Patent

and Trademark Office, Reg. No. 2,197,276

The Ultra Secure feature of Magicard® printers is protected by US PATENT No: 5,990,918 and by EUROPEAN PATENT

SPECIFICATION EP 0 817 726 B1.

Microsoft and Windows 2000, XP and Vista are trademarks of Microsoft Corporation.

SAFETY INSTRUCTIONS

To prevent electric shock do not remove covers.

Do not attempt to service the printer yourself.

There are no user serviceable parts inside. In the event of malfunction, refer servicing to your nearest MAGICARD

Service

Centre.

Use only a power source within the limits marked on the bottom panel.

Take care not to spill any liquid on the printer.

Ensure that the power supply cord is not longer than 2 metres in length and includes a properly grounded connection.

When handling the printer avoid touching the thermal printing edge of the thermal print head. Any grease and

contamination will shorten its life.

Before transporting the printer, remove the dye film & card hoppers and pack the printer in its original packaging.

If using this printer in Germany:

To provide adequate short-circuit protection and over-current protection for this printer, the building installation

must be protected by a 16 Amp circuit breaker.

Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit

einem 16

-Überstromschalter ab

esichert ist.