User`s manual

MAGIC-PRO MP-7VIP
12
USB Port Select JP7 / JP8
Redirect USB port2 to
USB2 connector (default)
1 3
1 3
JP7
JP8
Redirect USB port2 to
AGP
1 3
1 3
JP7
JP8
JP7 / JP8: USB Port Select (2)
JBAT1: Clear CMOS Data
Before you clear the CMOS data, its necessary to turn the power off first
(including +5V standby power). Otherwise, the system may work
abnormally or malfunction.
CMOS Status JBAT1
1
3
Retain Data (default)
1
3
Clear CMOS Data
JP9: Power Lost Resume
This feature must work with BIOS. Please refer to the BIOS Power On
After PWR-Fail sector.
Power Lost Resume JP9
1
3
Normal (default)
1
3
Enabled
RT2: Thermal Sensor Connector
a: Connect to RT2.
b: Connect this thermal sensor to
particular device which
generates lots of heat such as
Hard Disk, VGA chip, etc.
When connected, user could
observe the temperature
change from the BIOS
program.