Owner`s manual

Page 15
Figure 4 The wheelchair anchored pelvic belt
The wheelchair is not provided with a wheelchair anchored belt restraint as standard.
It must be requested at the time of ordering the wheelchair or it can be retrofitted
later on by a Magic Mobility Representative. The Magic Mobility supplied wheelchair
anchored restraint system conforms with WC19 and ISO7176-19 including section
4.9.2 through 4.9.5 and 5.2, and it has been used in the dynamic test of Annex A for
compliance with 5.3.
The pelvic belt should be worn low across the pelvis so that the angle of the pelvic
belt is within the preferred zone of 45° to 75° to the horizontal. Belt restraints should
not be held away from the body by the wheelchair components or parts, such as the
wheelchair armrests or wheels, see figures 5 and 6. Upper torso belts should fit over
the shoulders.
Figure 5 Correct positioning of belt
Shoulder belt connection pin
Shoulder belt connection pin