Owner`s manual

Page 14

Figure 3 Frontier wheelchair with seat removed showing locations of front and rear tie

downs used in the frontal impact test

The Magic Mobility Frontier wheelchair is to be used only with wheelchair tie downs

and occupant restraint systems that have been installed in accordance with the

restraint manufacturer’s instructions and SAE J2249. Attach the wheelchair tie downs

and occupant restraint system to the tie down brackets in accordance with the

manufacturer’s instructions and SAE J2249.

The tie down fittings have a rectangular aperture 25mm x 50mm. Any hook or loop of

the restraint end fitting must fit through this hole.

The wheelchair has been dynamically tested with a wheelchair anchored pelvic belt

as per the requirements in Annex A of WC19 and ISO7176-19. The belt anchor

points are shown in figure 3. The seatbelt is anchored over a 14mm spigot by an

M8x20 Grade 12.9 button head socket screw. Do not replace the pelvic belt with a

different style of pelvic belt; the belt supplied is designed to accommodate use on

either side of the vehicle. The belt is equipped with standard interconnect hardware

to enable attachment of suitably equipped vehicle anchored shoulder belts. See

Figure 4. The free end of the vehicle anchored shoulder belt is installed over the

shoulder belt connection pin.

Rear Tie Down

Front Tie Down