Owner's Manual

Discomfort
Charger and battery safety
You may experience some discomfort while using Magic Leap 2 including but not limited
to: visual discomfort, eye-strain, dizziness, nausea, impaired eye-hand coordination,
lightheadedness, impaired balance, excessive sweating, headache, fatigue, tingling, burning
or stiness, or numbness.
If you are having trouble with the Headset slipping in the back, or excessive nose or
forehead pressure discomfort, use the Overhead Strap.
If you experience discomfort, immediately stop using Magic Leap 2. If you decide to
resume use of the Device, before doing so, take a break and make sure you have properly
set it up, to reduce your risk of discomfort.
Your risk of discomfort may be heightened if: (i) you have never used Magic Leap 2 before;
(ii) the Device is not properly set up prior to use; (iii) you use Magic Leap 2 for extended
periods of time without a break; (iv) the Device is used to view content that has a high
likelihood of inducing motion sickness or nausea (e.g., AR applications where you are
moving through open areas or viewing heights); or (v) you have a history of motion
sickness, nausea, dizziness, eye strain, or headaches.
To minimize discomfort, consider slowly acclimating yourself to an augmented reality
environment by: initially limiting your use of Magic Leap 2 to shorter sessions and taking
breaks during use of the Device. Be mindful of the nature of the content that you were
viewing if you experience discomfort. You may re-experience discomfort if you view that
content again or view similar content, and persistent discomfort may increase the chance
of an injury.
If you have serious or persistent discomfort, please consult with your physician. Until you
have fully recovered, do not drive, operate machinery, or participate in activities that are
physically or visually demanding or require unimpaired balance or coordination.
The Compute Pack and Controller each contain a Lithium-Ion battery and come with battery
chargers. Please follow the instructions in this section to reduce the risk of injury to you or
others and to prevent damage to the Device and property. Failure to follow these instructions
may result in a hazard (such as a re, explosion, battery leakage, or electrical hazard), and may
cause damage to the Device or other property:
Do not try to change the battery inside the Device or open the Device to access the
battery, it is not user replaceable or serviceable. There is a risk of explosion if the battery
is replaced with an incorrect type.
Only use the batteries, chargers, and Power Cables we provide you to power Magic Leap
2. Do not substitute them with other power sources (such as other power adapters or
external battery packs), as other power sources may not be compatible with the Magic
Leap 2.
Do not use the batteries and chargers we provide you to power the Magic Leap 2 with any
other products.
Periodically inspect your connection cords and chargers for damage or signs of wear.
Do not use your chargers if the prong(s), enclosure, connector port, or connector cable
is damaged, cracked, or exposed.
Do not try to charge or use the Device if: (i) it does not turn on after attempted charging;
(ii) it overheats when it is used or charged; or (iii) the battery compartment is swollen,
leaking liquid, or smoking.
Keep chargers dry and avoid water or liquid intrusion. Even after the Device dries o after
coming into contact with water, the battery could corrode and increase the risks stated in
this Safety Guide. Also, do not touch the battery, chargers, or Cables with wet hands.
To reduce the risk of leakage or an internal short-circuit in the battery, do not disassemble,
pierce, crush, deform, drop, or put a high degree of pressure on the Compute Pack and
Controller.
06