Use and Care Manual

Floor surface
Place a level across the bottom of the tub
and adjust the tub feet leveler to touch the
level. Then raise the
leveler additional 1/8” or 3/16” so that the
weight of the tub, water and user are fully
supported by the feet adjuster and not the
tub walls.
Measure the actual distance from drain
into drain pipe on floor and the drain pipe
should extend approximately
1” above the finish floor. Use a drain
adapter (not provided) if necessary.
3
Step
4
Step
5. Clean the surrounding of the drain pipe
with cloth in preparation of seting the
drain, the area should be dry
and free of any debris. Apply a bead of
clear silicon or plumber putty around the
drain body and pass it through
the drain hole, also apply plumber putty to
the washer and slide it over the bothom of
the drain body.
5
Step