MODEL No.
INSTALLATION AND CARE GUIDE FREESTANDING BATHTUB SIZE 59 1/16” × 29 1/2” × 26 3/8” 66 15/16” × 31 1/2” × 26 3/8”
TOOLS REQUIRED FOR INSTALLATION (NOT INCLUDED) OTHER TOOLS MAY BE REQUIRED So Cloth or Blanket Silicone Safety Glass Knife Tape Measure Level Pencil/Marker Caulk Gun Hammer Adjustable Wrench Channel Lock Pliers 2 PEOPLE ARE REQUIRED TO LIFT AND DURING ti đ ti ti tt
INSTALLATION WITH UNDERFLOOR ACCESS Step ti ti ti Step 2 1
Step 3 ħ t Step 4 Step 5 .
Step 6 Step 7 Step 8
Step 9 ti Step Step 10 10 ti DO NOT SHOWER or MOVE the tub after installation because it will take about 24 hours to get the silicone sealant to dry. Note: ti annot move drain. ti You may consider following option. t may be used provement store the bathtub drain and the other end needs to ti ti Optional lsland tub drain may also be used. ti umber only because ti connection or loosen on any wrong connection will cause leaks.
INSTALLATION ON SLAB FLOOR (NO UNDERFLOOR ACCESS) Step Step 2 1 Turn bathtub upside down and set it on a non-abrasive mat, blanket, or cardboard to prevent any scratches on tub rim.
Step 3 Place a level across the bottom of the tub and adjust the tub feet leveler to touch the level. Then raise the leveler additional 1/8” or 3/16” so that the weight of the tub, water and user are fully supported by the feet adjuster and not the tub walls. Step 4 Step 5 Measure the actual distance from drain into drain pipe on floor and the drain pipe should extend approximately 1” above the finish floor. Use a drain adapter (not provided) if necessary. Floor surface 5.
PUTTY Step 6 Apply putty to fix the rubber silp gasket over the drain vent Step 7 Step 8 Apply a generous bead of adhesive or waterproof silicone to the botiom of the tub and caulk around the edge of the tub. Flip the tub over and carefully set the tub into position with tail piece assembly to waste vent and connect to the drain.
Step 9 Step 10 With the tub now set in place, wipe off any excess tub or tile caulking, adhesive where the tub meets the floor with wet cloth. DO NOT SHOWER or MOVE the tub after installation because it will take about 24 hours to get the silicone to dry.
IMPORTANT SAFETY RULES ATTENTION! ALWAYS FOLLOW THESE PRECAUTIONS WHEN USING A BATHTUB Warning The bathtub must be installed and used as described in this manual Warning Use cau on when entering or exiting the bathtub Warning Do not permit children or persons with infirmities to use the bathtub without supervision of an adult Warning People using any medications or having adverse medical history must consult a physician prior to use of the bathtub to avoid potential hyperthermia and possible drownin
