Use and Care Manual

CAUTION

BEFORE INSTALLATION

Before installation check that all fittings have been suppied.

Assembled bath on a mat to protect against damage to bath surface.

This product requires a two person lift-use proper lifting techniques.

This installation guide recommends a bath waste be fitted to the bath

prior to installation - if any doubt about Installation and waste connection

please consult a qualified tradesmen

Follow each step in turn.

WARNING

IMPORTANT:All installations must comply with council and local authority

by-laws. It is the responsibility of the installer to ensure that the waste is made

watertight by means of silicone sealant or caulking compound.

NOTE: Bath can be installed after the wall & floor tiling is completed. Bath drain

supplies should be arranged preliminarily according to the selected bath.

Ensure the floor where the bath will sit is level.

The waste & overflow is supplied with the product, however other items required

such as a waster trap and connectors are not supplied and must be purchased

and must be purchased separately.

Because of the technical features of the product it should only be used with the

waste & overflow supplied.

Handgrips for this product are not available.

The bathtub must be carried upside down, do not life or support the bath by the

sides.

Prior to installing the bath should be checked for damage as we recommend all

work is to be carried out by a qualified person.