Specification

by the metal washer and lock-nut.Hand
曰
Single-Handle Lavatory Faucet Installation
INSTALLATION MANUAL Tools You Will Need :
A
三
djustable wrench
�
Hexagon wrench
Notes before installation
Please check that all components
are present.
Before installation ensure that all
feed lines are clear of debris and
on/off valve is present.
�
wrench
�
glasses
Ensure water pressure is between
20-125 PSI (includes combination
of hot and cold feed lines).
Pictures in the manual are general
in content and may not represent
exactly your purchased faucet. If
you are having difficulties please
contact a professional plumber.
If you will be away from home
Remove the rubber washer,metal
washer and locking nutfrom the
faucet.
Screw andhand tighten the hot and
cold flexible hoses to the faucet.DO
NOTuse awrench totighten hosesas
this may damagethe hose and/orthe
for an extended period you should
shut off the main water supply.
Daily maintenance
l.Use a soft cloth and vinegar to
remove hard-water spots.
Check aerator (if present) regularly
for calcium build up are when
water stream is not optimum.
DO NOT use caustic cleaning
products as the use will break
down finish and will void the
product warranty.
Acceptable cleaners include
vinegar or mild non-abrasive
liquid detergents.
If the water pressure appearsto
hose threads.
3. Installfaucet through center hole .
4. Re-install therubber washer followed
tighten then tighten further using a
screw driver to tighten lock-nut screws.
be less than optimum remove,
inspect,clean or replace aerator.
Warning
NO TAPE NEEDED FOR INSTALLATION
Run the hot and cold valve
at least 15 seconds to
clear it before connect
5.Attach flexible hose to water supply.
Noise could be significantly
reduced by adjusting the
valv e wate r flo w