Installation Guide

4 / 8
Step 4
: Attach the mounting hardware to the prongs protuding from the
underside of the sink rim. Make sure the hooked side of the mounting
clip is facing away from the sink.
: Apply Silicone or Plumber's Butty
Clean and dry the surface around the opening of the sink; Turn the unit upside down to apply sealant
(not included) underneath of the sink rim.
: Secure Sink to Countertop
• Insert the sink into the opening, check the alignment of the sink to the cutout in the countertop,
and press firmly (Figure 4)
• Tighten the screws in the front of the sink, followed by the ones in the back and on
the sides of the sink (Figure 5)
• Remove excess silicone-based sealant
• Allow sealant to set for 30-60 minutes
Step 6
Step 5