Installation Guide
Table Of Contents
7
/
8
DO
1.
Clean Daily. Use a soft towel to wipe the sink with warm water. Mixing in some wash-er-fluid is advisa
Remember to wipe itdry.
2.
Remember to rinse the sink after using any cleaning agent and wipe dry. If any mineral deposits built
the sink, clean up it as soon as possible.
3.
Properly remove the rust, molds or scratches with a scouring pad. Rubbing the sink in the direction of
grain.
4.
Rub it lightly with a soft towel in the direction of grain lines.
5.
Keepthesinkdryafteryou useit.Because any standing water can causeabuildupofmineraldeposit,
which will become hard water stains.
DO NOT
1.
Leave water spots, utensils or steel cool-ware in the sink for a long time, which would become rust spots in
your sink surface.
2.
Leave cleaning agents or bleach sitting in your sink for a long period of time which may cause the sink to
discolor or damage thesurface.
3.
Use a steel wool or scouring pad rubbing against the direction of the grain.
4.
Leave rubber mats, cleaning pads or sponges in the sink for a long time as this may ruin the finish of your
sink.
5.
Use the inside of the sink as cutting surface.
How to use scouring pad correctly?
1.
Get a dry and clean non- scratch scrub pad.
2.
Scrub the rust off according to the direction of the grain.