SLIER INSTALLATION INSTRUCTION Step Parts list PART NAME Shower hose Washer Spray = O Flexible hose Weight Lock nut Quick connector Washer Screw 10 Body 1" Deck Plate SINGLE LEVER KITCHEN FAUCET
RECOMMENDED TOOLS The tools might be applied to the following places: Tools You Will Need: AS © Plumber's putty Pipe tape Philips Screwdriver pliers Adjustable wrench Notice: 1.Cleaning Before installation, shut off the water supply valves and clean up the water supply system. 2.Mounting hole Make sure the mounting hole size is between £/33mm£J35mm as show in the diagram. 3.Protection Clean the area of the mounting holes before installation.
Step Faucet installation i dies Note:To make sure that the pull out hose go back semimonthly need to adjust the weight in right position 1.Put the faucet into the installation hole. 2.Connect the shower hose to quick connect. Put the washer and gasket on the lock nut as Dis-assemble the weight and put is on the shown, then tighten with screws. shower hose. (Suggestion: diameter 35MM for installation hole) Then fix screws by screw driver.
3.Connect the flexible hoses to water supply valve, and tighten it with adjustable wrench. Don’t over tighten avoiding damage the washer. Warning: The supply valves are not included, please purchase them in plumb shop. «maintenance: temperate the faucet gently in order for a sustainable use. 2.Always blot dry any water from faucet surface.Clean with a damp non-abrasive sponge and wipe it with a clean soft cloth should be helpful to maintain good finish of the faucet.
Step Checking and testing ! Soh Sp C Note:Don't lost the O-ring filter. : 1.Remove the shower by hand.Turn the faucet 2.Check all connections at arrows for leaks, handle all the way on,turn on hot and cold water re-tighten it if necessary. supply and flush water lines for one minute. Reinstall shower by hand.
