Installation Guide

2
LINDO CENTERSET FAUCET INSTALLATION
INSTALLATION
1. Ensure that the water supply below your sink is
completely shut off by turning the valve all the way to
the right.
Tip: Place a small bucket below your workspace to
catch any water that may drip during the installation
process.
3. Insert the faucet into the prepared mounting holes.
From below, slide each of the rubber washers back
onto the threaded shanks. Secure the faucet by
tightening the provided lock nuts onto each shank.
Hand tighten firmly, then finish tightening with an
adjustable wrench if desired.
OFF
2. Remove the lock nut and rubber gasket from each
of the faucet’s threaded shanks. Do not remove the
plastic baseplate.
Rubber Gasket
Lock Nut
4. Connect the main water supply lines to the threaded
shanks of the faucet. Use an adjustable wrench to
tighten firmly,but be careful not to overtighten. Apply
thread sealant or plumber’s tape to the threads before
attaching.
Rubber Gasket
Lock Nut
Hot WaterLine
Apply thread
sealant or
plumber’s
tape
Cold Water Line