Use and Care Manual

3
Put the table top on the table leg, make
sure the reserved screw holes of the table
top and the frame are corresponding,
tighten 8x16mm screws from the bottom
to finish the installation.
This is a spare screw hole. When
the 8x16mm screw fails to be
screwed in, the hole can be fixed
with a 4x15mm self-tapping screw.
Either way will do.
8x16mm screw
and washer
Adjustable foot pads at
the bottom of the
support legs. (when the
ground is uneven, the
foot pads can be used
to adjust the balance)