ASSEMBLY INSTRUCTIONS 1/7
PARTS 1 2 Seat Body QTY:1 3 Backrest QTY:1 4 Cushion QTY: 3 Pillow QTY: 2 5 6 7 Arm QTY:1 Pair Leg QTY:4 2/7 M10 Washer (Outer Dim : 45mm QTY:4
Step 1 : Carefully unpack parts/hardwares from box and storage of seat body, place them on a clean flat surface. HARDWARE Storage, underneath of sofa body.
Step 2 : Place both arms as shown below, secure two legs and plastic washers into pre-drilled holes on the bottom of arms. Please avoid over tightening.
Step 3 : Carefully lift and turn assembled arms onto its legs. Insert seat body metal plates to both arms as shown below. Ensure it is correctly in place.
Step 4 : Insert backrest metal plates to both arms as shown below. Ensuring it is correctly in place.
Step 5: Finally, stretch and pull down rear cover evenly before securing velcro strip to seat base. Repeat if necessary for better fit.
